ADTRON’S Stepper Motor Demonstration unit is a versatile self contained stand alone unit useful in the
study and demonstration of the principle and working of a stepper motor with various electronic controls such as
manual switching and Microprocessor based controls. Provision for direct up interface is provided. It consists of two
units viz., stepper motor unit and the translator unit. Each unit is housed in an elegant cabinet with a well spread
intelligently designed circuit layout on the front panel. Multicoloured test points are provided at various stages in
the circuit to observe the waveforms and voltages. It is strongly supported by a comprehensive instruction manual
complete with theory, operating details and machine code program.
STEPPER MOTOR UNIT :
Motor : Bi – directional with permanent magnet rotor & bifilar wound stator.
Motor Characteristics : Self starting, low moment of inertia, instantaneous start, stop and reversal of rotation.
Rotation : 200 Steps / revolution.
Torque : 10 kg cm^2
Stepping Angle : 1.8 deg.
Protection : Against forcible stalling.
Operating Voltage : 12V DC.
Mounting : Motor mounted in a metal cabinet with a calibrated dial and pointer.
Connector : Special connector with wires to connect motor unit to translator unit.
Panel Size : 8” x 10”.
TRANSLATOR UNIT :
Translator : Versatile solid state electronic switching circuit for conversion of input pulses.
Output : Required pulse pattern for driving the stepper motor using digital circuitry, analog demultiplexer & power amplifier.
Type of Control : 1. Number of steps.
2. Speed of revolution.
3. Direction of rotation.
DC Source : Translator : + 12V DC Regulated.
Motor : + 15V DC Unregulated.
Pulser : Bounceless manual pulses.
Clock Generator : Variable clock frequency generator with high / low and fine control.
Controls : 1. Mains ON / OFF.
2. Manual Pulser.
3. Forward / Reverse rotation switch.
4. High / Low variable clock for speed.
5. Potentiometric Fine Control for variable clock.
Test Points : Provided at various stages in the circuit to observe waveforms & voltages.
Indicators : 1. Mains ON / OFF.
2. Logic level indicators for monitoring the logic status of each winding of stepper motor.
Connector : Facility for connecting the motor unit.
Power Requirements : 230V, + 10%, 50Hz, 1f.
Panel Size : 8” x 10”.
Standard Accessories : 1. Detailed Instruction Manual.
2. Set of required number of patch cords.